![]() serial_stop_bits = 1, /* Assumed since manual makes no mention */Ħ4. serial_rate_min = 4800, /* Default rate per manual */Ħ2. Here is the source of hamlib, yaesu/ft450.c:ĥ9. ![]() set-conf="ptt_pathname"="/dev/ttyUSB0"look here : - perhaps you've checked, but are you sure, there isn't Rigctl -v -m 127 -r /dev/ttyUSB0 -set-conf="ptt_type"="RTS" Works.Tried with all proper baud match.right, ![]() I'ld enabled that.Īlso looks like the serial speed is 4800, not 38400, but it could Through the CAT, it used with RTS, so the RS232 flow should beĭisabled. The PTT was probably activated from my Signalink interface (flrig -> fldigi -> signalink -> rig)CAT RTS disabled (in my opinion) means that PTT started not ![]() Mail, that you can "pushed" the PTT - that mean, the RTS is worksĪs PTT.Test with CAT RTS set to DISABLE (still no rig control) The default value is ENABLE, but you wrote in a Looks like there is an option in menu, that you can disable ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |